Zani research and development department has designed this machine for a very particular application in the deep drawing field producing parts over 120mm depth in just one shot and with a very high productivity.

The press is driven by a high torque Servo motor combined with a knuckle joint leverism system.

Thanks to this solution we reduce a lot the frame deformation, typical of the “C” frame presses, because the main pin that has to resist against the reverse load is positioned inside the press frame and not just over the ram where normally the crank shaft of c-frame eccentric presses is located.

The press is also equipped with a plunger system in order to have a better guiding of the ram movement, a hydraulic cushion in the bed and a pneumatic ejector in the ram.